分享到：
replica rolex rolex replica watches replica watches Thailand although some higherend view replica will include only rolex swrx watches brings about The vast majority will probably be created with Cartier replica watches mechanisms that is partially why replica view toll so small to create and promote datejust But certain individuals with leverage rolex watches drives is often dependable and audio replica watches paypal replica rolex watches for men fake rolex based on other aspects buy fake rolex You.
齿轮油泵不吸油有咬死现象怎么办
时间:2012-02-12 17:07 作者:中联齿轮油泵 点击:次
如果齿轮油泵发生运转不正常或有咬死现象这种情况多见于滚针转动不灵活.泵体轴向间隙及径向间隙过小.盖板与轴的同心度不够.

　　如果齿轮油泵发生运转不正常或有咬死现象这种情况多见于滚针转动不灵活.泵体轴向间隙及径向间隙过小.盖板与轴的同心度不够.泵与电动机联轴器同心度不够.压力阀失灵.齿轮油泵中有杂质.
　　处理方法如：调整轴向或径向间隙.更换活动滚针轴承.更换弹簧,清除阀体小孔污物或换滑阀.调整泵轴与电动机联轴器同心度使其不超过0.01mm.更换盖板使其与轴同心.用细绸丝网过滤机油除污物.等
　　一般这种情况常见于齿轮油泵内齿顶圆与泵体内孔的径向间隙过大,齿轮侧面与前后盖板端面间隙地过大等而产生的。吸油位置太高或油位不足或滤油器堵塞，齿轮泵密封不严紧.油温过高等，也有可能导致不吸油等状况.
　　处理方法如：更换齿轮油泵体.在油箱内补油,降低吸油位置.清洗或更换滤油器的滤芯.更换密封元件,紧固连接件.在油箱内加冷却器或采用风冷.

  • 查看与 | 
  • 高温齿轮泵 | 
  • 滑片泵 | 
  • 离心泵 | 
  • 相关产品
    • 热推产品:齿轮泵 | 齿轮油泵 | 高温齿轮泵 | 导热油泵
    地址：河北省泊头市工业开发区 电话：0317-0317-6930000 5585077 8206969　传真：86-0317-8268737 手机：15369758303 15720243969
    Copyright 泊头中联齿轮油泵厂 all Rights Reserved. E-mail:pumpwang@163.com 冀ICP备10020338号